English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The results of a pre-oxidation heat treatment at 930 °C in Ar/H2/H2O environments on a Si-bearing Nb-stabilised 20Cr25Ni austenitic steel are presented. The heat treatment was conducted under low pO2, achieved by the introduction of controlled amounts of moisture into the gas. The atmosphere promoted the formation of a continuous, dense, adherent, protective surface scale composed of Cr2O3 and MnCr2O4 with a thin Si-rich oxide at the oxide alloy interface. Samples with different oxide layer thicknesses were produced and further exposed at 700 °C, to a gas of nominal composition CO2/1%CO/1000 vpm C2H4 for 4 h. This gas mixture has a carbon activity greater than unity and readily forms filamentary carbon on the non-pre-oxidised alloy. This is catalysed by nickel particles formed intrinsically from the alloy during the early stages of oxidation of the unprotected surface. The oxide layers produced, as a result of the pre-oxidation process, could suppress carbon deposition onto the alloy; a significant reduction in carbon deposit was noted with an oxide of 125 nm thickness, and no deposit was found on the sample with an oxide thickness of 380 nm. The depth of depletion of chromium from the alloy correlated with the thickness of the oxide formed during the pre-oxidation heat treatment, but the chromium concentration at the oxide/metal interface remained at ~ 15–16 wt% and considered to be sufficient to reform a protective layer in the event of mechanical damage to the original. No additional chromium depletion of the alloy occurred during the 4-h deposition stage.

Influence of Pre-oxidation on Filamentary Carbon Deposition on 20Cr25Ni Stainless Steel